.jpg)
INTRODUCTION
The Corvette C6 has been, since 2005, the epitome of speed and style. A body kit can make this amazing car more stylish and enhance its performance. Now, this guide will walk you through installing the ModeloDrive FRP GT3-XL Wide Body Kit to ensure your Corvette's standout.What is the ModeloDrive FRP GT3-XL Wide Body Kit?
The ModeloDrive FRP GT3-XL Wide Body Kit is designed for the Chevrolet Corvette C6 (2005-2013). It is made to flaunt superior quality, flexibility, and lightness since it is fashioned from FRP—Fiberglass Reinforced Plastic.
Preparation Before Installation
Get at your disposal screwdrivers, wrenches, a drill, sandpaper, body filler, primer, and double-sided tape. Wear gloves and goggles; safety first. If you are not confident enough in doing this on your own, consider professional installation.
Unboxing and Inspecting the Kit
Carefully unbox the body kit and check for all its parts. Check for damages or imperfections. Knowing the layout definitely helps in the process.
Dry Fitting the Body Kit
Dry fitting checks the proper fitment:
- Place every component.
- Mark up alignment points.
- Check for gaps and misalignments.
Modifications and Adjustments
Some modifications may be needed, such as shaving, sanding, and drilling. When working with fiberglass, be careful not to further damage it.
Preparing Your Car for Installation
Clean the surface of your car and remove any existing parts if necessary. This is necessary to provide good fitting and adhesion.
Installation of the Front Bumper
Install the bumper at the front of your car using bolts and screws. Ensure that the gaps are even and adjust them if necessary.
Installing the Side Skirts
Place the skirts, fix them using tape and bolts. Make sure there is no looseness; make any adjustments necessary.
Fixing the Back Bumper
Align the rear bumper, drill holes, and fasten. Check the alignment with the rest of the kit.
Mounting the Fender Flares
Align and mark the flares; then drill holes and fasten with bolts. Edge blend with existing body lines.
Final Adjustments and Inspections
Inspect the general fitment for the appropriate fit and make any necessary changes. Ensure that all parts are firmly attached.
Conclusion
Upgrade your Corvette C6 to a new look with a boost in performance with the ModeloDrive FRP GT3-XL Wide Body Kit. While installation is relatively easy if you follow these steps, for best results, professional help can help. Check out our 2005 Corvette Body Kit at Carbonfiberhoods.com.
FAQs
Can I install the body kit myself?
Yes, but installation by a professional is recommended.
What tools are required to install it?
Basic hand tools, an electric drill, sandpaper, body filler, and primer.
Will I need to modify any of the fiberglass parts?
Generally, yes. Sanding and drilling are almost always required; filling sometimes is.
How do I prepat the fiberglass for painting?
Sand the surface, primer, then sand again.
Does the body kit by ModeloDrive have a warranty?
You should contact the manufacturer or their distributor about warranty on that kit.
#2005 Corvette Body Kit